Partial Knob-and-Tube Rewiring in Everett

Typical cost in Everett

  • One room, such as a bedroom$2,500 – $6,500+
  • Two or three rooms, or one group of circuits$5,000 – $12,000+
  • One whole floor$8,000 – $18,000+

A partial rewire covers only part of the house, so the first job is finding the circuits that are still live and the parts already updated. The new work has to stop at a clean point in the wiring, and we find that point by tracing the circuits.

We work in Everett and also take jobs in Mukilteo, Marysville, Mill Creek and Snohomish. Include the address and we will confirm we work there.

Tell us about your project

Blue-gray Craftsman house with cream trim, a covered porch, and mature landscaping

Partial replacement situations

Old ivory outlet pulled from a metal box in a plaster wall, with cloth-covered cable entering the box

Remaining old circuits after earlier upgrades

A house can have modern wiring running alongside older circuits. We test what is live, note which rooms and outlets each old circuit feeds, and work out how the new wiring joins the wiring that stays. Old permits, invoices and drawings help us plan, but we still check the wiring itself. Our estimate lists the circuits we replace and the ones left out of the job.

A defined group of rooms or circuits

You may want only a few rooms done, but an old circuit can run past the doorway. We follow each one to see what else it feeds. Before we agree the work, we map out how to reach the wiring through the attic, the basement or finished walls. That is how we tell a partial rewire that will work from a list of rooms that ignores how the circuits connect.

Closed gray electrical panel on a pale basement wall beside a high window

Phased replacement with a record

If you rewire in stages, each stage ends with a note of what we replaced, what is still old and what the next stage will need. We only split the job where the circuits allow it, because not every part of a house can be cut off from the rest. We also show you what separate stages add in access and patching compared with one larger job.

Replacement, removal and the wiring that stays

Replacing knob-and-tube means moving the power onto new wire. Taking old wire out is a separate step. We split the job into new grounded circuits, old circuits disconnected, and old wire removed where we can reach it. We work with the inspector on how to handle old wire hidden in closed walls. A quote line that just says “remove knob-and-tube” leaves out the hidden runs and the wall repairs, so we spell out both.

Most rewiring needs a permit and inspections. We find out which office issues the permit for your address and plan the inspections around the work. We suggest panel or circuit changes only when our check shows a need. If an insurer asked for the rewire, send us its list of required paperwork; whether it accepts the house is still the insurer’s decision.

Get a quote for your partial knob-and-tube rewiring project

We need the address, the rooms or old circuits you want checked and any earlier rewiring records, plus photos from any spots you can reach. Use our quote form to send it. Or call (425) 645-4346.

Get a quote for your project

Call (425) 645-4346